Serving Jefferson City, Columbia & the Lake of the Ozarks · Mon to Fri, 8 AM to 5 PM
EWulff@WashAuthority.com Live Cleaner. Live Happier.
Get a Free Quote
Call or text, Mon to Fri 8 to 5 (573) 418-9942
Driveways, patios, walks and parking lots

Concrete sealing in Jefferson City, MO

Concrete sealing in Jefferson City keeps water, salt and oil from soaking into your driveway, patio, walks or lot. First we wash the slab with hot water, then we seal it once it dries.

At a glance
  • What it is: a clear sealer that slows water, salt and stains from getting into concrete.
  • What is included: a hot water wash, drying time, then the sealer.
  • Who it is for: driveways, patios, walks and commercial lots that have seen a few winters.
  • When to book: any dry stretch before winter, so the sealer is on before salt season.
  • How to get a quote: use the online form, or call or text (573) 418-9942 and send photos if you have them.

Should you seal your concrete? Four checks before concrete sealing

Run these four checks in order. If your slab fails one, the answer is not yet.

  • Age. If it was poured this year or last, wait. Fresh concrete is still curing, so ask whoever poured it how long to hold off.
  • Clean. If it is dark, green or greasy, it needs a wash first. Sealer bonds to whatever it lands on.
  • Sound. Wide cracks, sunken panels or a flaking top layer need a concrete contractor first. Sealer is not a repair.
  • Exposure. Salt, oil, tires, standing water and leaf stain make sealing worth it. But a dry, covered, lightly used slab has little to fear.

If you pass all four, it is time to seal. If only the exposure check fails, a plain concrete cleaning may be all you need.

What is included in a concrete sealing job

Every sealing job starts with a wash, because sealer locks in whatever sits in the pores.

  • Hot water wash. First, our custom-built hot water skids run over 235 degrees with formulated cleansers. That lifts environmental soiling, most oils and small debris.
  • Drying time. The slab has to dry through before any sealer goes on. So a sealing date can slide a few days for weather.
  • The sealer. We go over the finish, sheen and grip with you before it goes down.
  • Straight talk. A deep oil spot can still leave a faint shadow. If so, you will hear that from us before we seal.
BeforeConcrete steps covered in green growth before a hot water wash and concrete sealing
AfterThe same concrete steps after a hot water wash, clean and dry

Steps before and after the wash that comes before any sealer.

You can read more about the wash on our hot water pressure washing page. Also, the wash and the sealing are separate lines on your estimate.

Concrete sealing for driveways, patios, walks and lots

The right call changes with the slab. Also, brick, stone steps and block walls next to it are a separate job called masonry sealing.

SlabWhat it fightsOur read
Driveway Tires, road salt and engine drips Worth it once the slab has a few winters on it, because the apron takes the worst of the salt.
Patio Shade, leaf stain, algae and grill grease Yes if it holds water or stains easily. Under oaks and maples, the patio looks tired first.
Walks and steps Deicing salt, shovels and wet shoes Yes where salt lands. We also talk through grip, because it matters most here.
Commercial lot Tires, fuel, deicers and plows Worth it on sound drive lanes and walks, but not on a lot due for repair. We phase the work so you stay open.
Paver patio Washed-out joint sand, weeds and ants Fix the joints first with polymeric sand.

What concrete sealing does and does not do

It helps with

  • Water. Less soaks in, so less freezes and flakes the surface in winter.
  • Salt. Deicer has a harder time getting in, so the apron pits less.
  • Stains. Oil and leaf stain sit on top longer, so the next wash is easier.

It does not fix

  • Cracks and settling. Sealer will not close a crack or lift a panel, so repairs come first.
  • Old stains. It locks in whatever is under it, which is why we wash first.
  • Wear. Tires, plows and shovels still wear the surface.
  • Roof runoff. If a downspout dumps on the slab, start with gutter cleaning.

When to reseal concrete

We will not hand you a number of years, because a sunny driveway wears faster than a shaded patio. Instead, do a splash test.

Beads up and sits thereThe sealer is still turning water away.
Darkens and soaks inThe slab is drinking water again.

Pour a cup of water on a clean, dry spot. If it beads up, the sealer still works. If it darkens and soaks in, it is time to reseal.

  • Dirt, algae or leaf stain comes back faster than before.
  • Oil sinks in instead of sitting on top.
  • If the film looks cloudy or peels, that is concrete sealer repair, a separate job.

Own a lake house or a rental? Then do the splash test each spring when you open up at the Lake of the Ozarks.

Concrete sealing questions

It can, if the sealer leaves a film on a smooth surface that gets wet. So we talk through the finish and grip with you before anything goes down, especially on steps and walks.
Only if the slab has dried through and the weather is clear, and that is not always the same day. Sealer over a damp slab causes trouble, so the date follows the forecast.
Not until the old film is handled. New sealer is only as good as what it sticks to, so a peeling or cloudy layer becomes a concrete sealer repair job first.
Mostly the square footage, how dirty or oily the slab is, and any old sealer on it. Access, the number of separate slabs and phasing around traffic on a commercial lot matter too. Photos and a short description help us bid accurately.

Bring us the slab you are not sure about.

Send the rough size and a photo, and we will tell you if it needs a seal, a wash or a season of waiting.

(573) 418-9942
Send a text
EWulff@WashAuthority.com
Jefferson City, Missouri
Monday to Friday, 8 AM to 5 PM Commercial clients: fully insured, workers' compensation, and a certificate of insurance on request.
CallText(573) 418-9942